The SWAN AMI Deltacon P water quality analyzer is a complete monitoring system for the automatic, continuous measurement of the conductivity before and after a cation exchanger. Calculation of the sample pH value and alkalizing reagent concentration based on differential conductivity measurement.
- Simultaneous measurement and display of conductivities, pH or ammonia concentration, sample temperature and sample flow
- Monitors specific and cation conductivity (specific/total conductivity and acid/cation conductivity)
- Factory tested, and ready for installation and operation.
- Complete system run in factory for 72 hours prior to shipment
- Robust temperature compensation - up to 130 Degrees C
- Performs calculated pH by differential conductivity
- Calculates ammonia concentration
- Monitors sample flow to insure accurate measurements
- Electronic drift stabilization increases accuracy, reliability and reduces calibration frequenc
- Optimal cation exchanger design and flow path
- Sophisticated internal diagnostics to validate analyzer results
- Two precision conductivity sensors with slot-lock design and integrated Pt1000 temperature probe.
- Easy to replace cation exchanger
- Automatic deaeration of the cation exchanger
- Calculation of resin consumption with user alarm
- Optional pre-rinse setup for instantaneous resin exchange
- Built-in PID controllers with relay and mA outputs (Optional Modbus output communicates ALL measurement values and diagnostic data)
- Three year warranty on electronics
